Sensors for DIE CASTERS. Measure Locking Force and avoid the Bar Breakage
Tie Bar Strain Sensors Prevent ,
Broken Tie-Bars, Flashing and Mold Wear
Locking Force Sensors Tell You, Actual Locking Tonnage Online
TIE BAR STRAIN GAUGES
The perfect help FOR MAXIMUM, UNIFORM
CLAMPING FORCE
without overloading toggles or tie bars
Avoid tie bar failures
Keep mould and machine aligned
Extend bushing life
Less mould wear and flashing
Verify actual press-tonnage
Repeatable setup from run to run
FEATURES:
Quick and Easy mounting with two super
magnets
2 sensors for bending compensated
measurement
Fully electronic system, latest technology
Fits any tie bar diameter
High resolution – 1% accuracy
Signals can be recorded and stored
Direct tonnage reading – no calculation
Left: 2 QE1008
sensors on a tie
bar for bending
compensated
results. Below:
easy mounting
by pushing down
the screw.
With 8 sensors,
the tie bar stretch
is automatically
measured bending
compensated.
This is for fastest
results and direct
total clamping
force indication
with 1% accuracy!
DU-4/D unit
displays directly tie
bar longation, kN
or tonnage. USB
output (opt.) and
software available.
Ordering Information:
Set with 2 sensors: No. QE1008/2
Set with 4 sensors: No. QE1008/4
Set with 8 sensors: No. QE1008/8
All sets in carrying case with inserts, sensors,
digital display unit, connecting cables, manual,
and GND-cable. Optional USB cable and
software to record and store data.
